Just installed some new RAM, so I unplugged everything from my PC to get better access. Now that I plugged everything back in it seems that my screen is not getting any signal and just goes to power saving mode when I turn my PC back on. Tried every possible combination of the DP and HDMI ports that my computer has but it just won't work. Did I fuck up?
even checked to see if everything is properly seated, seems normal to me
wrong image in the previous post, this is the correct one
>>1522569ok the PC runs normally when I take out the new RAM, anybody know what's up with that?
>>1522576ur new ram sucks ass
take pic of label on the old and new ram.
Hope you didn't mix RAM types.
>>1522569loosen your gpu screw and then plug the cable in
>>1522569Are you able to boot into BIOS? If you can, check if XMP and Fast Boot is turned on then turn OFF Fast Boot and XMP, save changes then restart. Check the specs of your RAM and make sure everything looks good.
>>1522576The new RAM is fucked, RMA it.
>>1522569memtest86 each ram stick individually
>>1522583>>1522593Answer to these you stupid blind nigger faggot OP.