im looking to diy this bed and i refuse to pay 275 for these parts alone. how?
these are the parts
have you tried turning it on and off again?
>>2989090How does the mattress stays in place?Buy flat bar steel, fold them and weld them if needed then paint.
Buy metal, then bend & weld it into those shapes.
>>2989090Wow what a shitty design. It's seriously held together with the ratchet straps?>>2989164If this mattress is sliding around this is the most bullshit bed. It looks like there is basically no ventilation to the bottom of the mattress because the boards are so wide. It's barely different from putting the mattress on the floor.
>>2989090Forget steel parts. Make whole thing out of wood.Pls excuse my chicken-scratch hand drawing.Dimension as needed for mattress. Suggest letting mattress hang an inch or two over frame or shins get beat up finding bed in the dark.
>>2989279I'll never understand the draw towards bed frames like this where there is supposed to be a bit of spring to it from all the small slats. My bed frame is made out of a solid 2x6 frame with 100% covered 3/4 plywood deck. It's completely solid with basically no give, and it works absolute wonders with the cheap ass 6in foam mattress I have. I'm not even a firm guy, I side sleep and prefer soft mattresses but something about the setup just works
>>2989289its for airflow through the mattress, not springiness
>>2989164is mattress on floor bad? my mattress has always been on the floor.
>>2989324If on a basement concrete floor, the next morning it's gonna look like you peed you bed then flipped the mattress.
