I'm trying to install a utility sink in my basement, but I can't quite figure out how to plumb it. I went to home depot, and they have lots of 3/8-inch Compression x 1/2-inch FIP x 16-inch Stainless Steel Faucet Flex Connectors, but in this case the supply lines all seem to be the wrong size?The supply line inlet threads seem to be 3/4" OD, the outlet line threads coming from the wall are 1 inch OD. I couldn't find anything prebuilt that fits that.Also, it has a 2 inch diameter drain thread on the bottom of the sink, which I will have to drain presumably through a hose into the floor drain of the house, what kind of tubing and connector would I have to use to make such a drain hose? (Plumber said that it could not be connected to the regular ABS drain pipes because they are up too high.)Ty for help
Here are the wall faucet valves and the floor drain pipe.
>>3015837pic related
I understand I'll have to make a custom drain hose to connect to the sink, should I use something smooth like vinyl tubing, or a ribbed sump pump hose? Feels like paint would get caught in a ribbed hose if I was washing my paint shit regularly
>>3015838Those are GHT valves (garden hose threads). I would tee off a copper run (or PEX) from behind that valve over to a stub-in behind the sink. Then install 1/4 turn shutoffs and faucet connector hoses.If the floor drain goes to a sump pump then your sink water will end up in the gutter and storm drain.
>>3015843The piping is all copper for sure this house was built in the 50s. Would I need to solder all that in?
>>3015869You could use Sharkbite connectors but if it were me I'd cut and sweat copper tees on the hot and cold supply lines, and then sweat PEX expansion adapters onto the tees. Then you can run PEX uninterrupted all the way to the stubs.https://pexuniverse.com/pex-copper-fitting-adapters
>>3015878Ohh okay I like that. I guess I would need to find a torch and pipecutter to do that, but I have soldering experience. If I can't I'll do sharkbites. Gotta cut into this paneling too I guess.
>>3015882>Gotta cut into this paneling too I guess.That's the fun part lmao. Just make sure you use PEX-A pipe (expansion-type fittings) and secure the pipe with j-hooks along the run. If the pipe bends or kinks you can heat it up and fix it.
>>3015885If I'm running it straight out of the wall (haven't seen where it's coming from yet desu) would I just let the wall support it pretty much? It would likely be 2 inches of pipe at most.
>>3015888It should be secured where the PEX connects to the shutoff valves so it doesn't jump around. If you want it to look pretty, slide escutcheons over the pipes before you connect them to the shutoffs.
Plumbing shit doesn't go by pd so don't buy anything by those numbers. What does the listing for the sink say the connections are? You have compression nuts on the inlets and it's an 1-1/2 thread on your drain
>>3015955What does pd mean?
>>3015974Assuming anon meant OD- outside diameter.
>>3015836you didnt figure this out before getting a sink?
>>3015836The big question is why do you need this sink in the basement. Are you disposing something you shouldn't? A serial killer in training?.