SSBmaW5hbGx5IGRpZCBpdC4gaHR0cHM6Ly90Lm1lLysySExzanJPTjBiQXhPRGhs

File: 1769863553577523.gif (204 KB, 220x159)

204 KB GIF

>>98113865

>>98113865
kino

>>98113865
joined

File: IMG_0882.jpg (1.98 MB, 4032x3024)

1.98 MB JPG

Question about supports, and, before I go further, I did watch videos but I would like your input/tips: I have been using autosupport for structures on Lychee, it’s led to some damage of the figures details (Pits, chips, etc)
If I’m printing say, figures in pieces, (arms, legs, heads) how many supports do I truly need? Now I will say I understand with bulky or heavy models you need to have better supports, but if I’m printing smaller figures, or their details, say like a blade or staff, what would that look like?
Also, side quest question, what kind of snippers should I use? Because mine I’m assuming aren’t of good quality.
Attached is a pic of latest print, came out well, had to learn about scaling after, well, you see his little brother.
Plus, printing today, if all goes well I’ll post follow up pics if anyone wants, any info/critiques are welcome.

>>98115339
>If I’m printing say, figures in pieces, (arms, legs, heads) how many supports do I truly need?

Probably not as many as you think, but its impossible to give you an answer that is valid in general. There are so many factors to consider, from the file in question itself, to your resin, your lift speed, the age of your fep etc.

>>98113865
yay

File: wat.png (100 KB, 1162x762)

100 KB PNG

Dude what the fuck

>>98115339
Try manually supporting if you want an answer to your Q. Start with something infantry sized; go bottom up, hit every island that pops up with your smallest support size. Replace/supplement a couple of those supports with your next size up towards the bottom as anchors (shoot for the soles of the feet; if those scar, you don't have to care). Add a couple more supports here and there where you think the model is going to get stressed while printing. When you think it's enough, it probably is.

>>98118138
Is this from the new slicer dragonfruit or was the file fucked from the start?

>new tranny
>thread dead
was it a mistake?

File: Jannies Ogre WIP.png (1.73 MB, 2015x1491)

1.73 MB PNG

Shameless shilling here. Working on posing up my Macarbe Janitor ogres.

Will be done this weekend.

does anyone have stls for the EC army and or the new defiler? i kinda need rhinos, spawns, tormentors, infractors, exultants and daemon princes. i just got into the hobby and i am not selling my soul ( yet) to GWendolin. Also OP is a fag.

There was this rather nice leman russ model on makerworlds by two goblins in a coat, sadly GW takedown seem to got it down and I foolishly deleted my file after printing it, if anyone got it could you throw into some archive to share around for those who would like to use it?

>>98125799
bWF5YmUgY2hlY2sgdGhlIHRhbmsgb2YgV2FyZ2FtZSBUZXJyYWluIFByaW50IHRoZXJl

>>98125956
That would be close, but different design then one I was after

>>98124573
as long as you're posting it here, shill away brother. those look cool