I am making a mask to 3D print for halloween.Why isn't it bending properly when I use lattice? I want it to bend so it's easier to fit over my face. Some parts stay back and it causes the mask to look choppy and deformed.What am I doing wrong?
You should up the resolutionnon that mesh by a lot, a lot.Otherwise it's hard to tell from just this angle. The outer verts of the lattice might need to be moved too. It may also be the case that you need to exagerate the bend in the lattice to get the mesh to bend the way you want. Thats typical.
Its also helpful if the lattice shape is closely shaped tothe mesh youre deforming. Your lattice is way thicker than your mask.
>>1021031>What am I doing wrong?Well, you're trying to make a mask using a lattice for a start.
>>1021031>>1021058>>1021059It's also possible that your mesh has unintentionally disconnected geometry (multiple vertices exist in the same position), try selecting all vertices in edit mode, press m - "merge by distance".
