Imho, try to get a beginner origami book. Like John Montroll's. Fold a few models. You'll realize the Asian guy didn't do very complicated stuff. And you can replicate it after you open it.

Obviously practice turning your folds into flat paper again before opening this one.

>>627756
>opening this one
film it so you can post a WebM if you get stuck

>>627754
yeah, it's a waterbomb base, then flatten in half the top and bottom flaps, petal fold the top flap, that will make the head/beak
modify the tip so it looks like a head, and decorate by cutting the feathers in the wings and tail
I could draw you a diagram but with these instructions and a bit of bing search should be enough
it's pretty simple frien
also fuck these unhelpful bastards

>>627864
Please stop larping as an expert. It’s off-putting.

File: bird-1.jpg (1.98 MB, 1000x4000)

1.98 MB JPG

okay, here's my best shot, /po/
>fold a square piece of paper horizontally, vertically, and across both diagonals. fold three corners to the center, then cut along these lines
>make a waterbomb base from the remaining square
>fold halfway
>petal fold the top flaps up across that previous fold

File: bird-2.jpg (1.81 MB, 1000x4040)

1.81 MB JPG

>reverse fold the top corners
>make the folds to the center for the entire square
>open the paper up, sink in the fold
>do the same for the other side

File: bird-3.jpg (2.35 MB, 1000x5000)

2.35 MB JPG

>your model should look like this now
>take one of the top 'pincers' and unfurl both folds to have this tag sticking out
>reverse fold along the small fold you just unfurled to make the tag slimmer
>open up both 'pincers'. insert the edge marked orange directly under the edge marked green
>you should now have three flaps that can move freely from one another

File: bird-4.jpg (2.09 MB, 1000x5000)

2.09 MB JPG

>mountain and valley fold along the neck to form the head and beak
>flip the model over. fold the horizontal fold from earlier back. after this, you can optionally curl it
>fold the paper across the main diagonal
>fold the paper back down (with this, I just folded back around 1/4 of the trapezoid height)
>flip the model over again. make cuts for the wings. on the bottom tail section, trim the sides off to be similar in width to the head, then remove the trimmings (watch out for any little bits that are still barely connected to the wings). then make cuts for the tail feathers

File: bird-5.jpg (1.55 MB, 1000x3000)

1.55 MB JPG

>your model should look like this
>fold the length of wound-up paper back, its thickness will help you shape the body. then shape the head, beak, wings, and tail
this ended up being a cute model, thank you for the challenge, OP

>>627876
I kneel.

i will also add that once you shape the bird, you can hold it like a dart with your fingers on the wing joints and then throw it. it has good momentum and gives some nice twirls for show

>>627879
Wat.

File: launching-paper-airplane-(...).jpg (12 KB, 547x260)

12 KB JPG

>>627883
throw it in the air.
it moves like a Badminton birdie

>>627884
>Badminton birdie
Wat. Those don't fly when thrown.

>>627886
make a bird and find out

>>627754
it looks similar to a swallow i wonder what bird it is