hi yall,i rented a VX10RSPRO bridge saw and i am having trouble with getting clean cuts and tolerable miters. i have since ordered a new blade and i will use a clear vinyl tape over the cut mark. my question, should i have bought a diamond blade or a masonry blade? they both have their pros and cons…I also have a problem with the miter, i think the saw is not able to reach 45 degrees, it can only do 46 or 47 degrees, which is enough to mess up what i am making. because of that, i purchased an electronic inclinometer. hopefully this helps me get a clearer picture of what is going on.is there any other equipment or information you recommend for reducing chipping and getting perfect miters on a bridge saw?thanks, masonryanon
