I literally just got this figure and I put the stand in and it immediately broke when I took it out… How can I get it out and is the stand still salvageable? This is my first revoltech figure and I’m extremely disappointed
Take a tiny screwdriver and heat the end with a lighter. Push it into the plastic peg. Let it cool down then pull out.
dont be a retard and do shit like >>10981040. buy a pin vice set and drill down into the broken peg. heat the area with a hair dryer and remove.
>>10981040>>10981058Would it be possible to superglue the stand back together and still use it?
>>10981037>Those nails>Greasy hair on figureGross
>>10981063Just buy an actionbase6/7 and cut your losses, glueing a clean break like that does fuck all to fix the structural failure that broke it in the first place.
>>10981076It's an adult playing with an action figure, what did you expect?
>>10981037Get a lighter and a sowing needle, gloves recommended as well. Heat up tip of needle till its red hot. Insert hot end into the peg at 30-45 degree angle. Let the needle cool. Pull out needle and peg in the direction of the peg hole.
>>10981037Which Revoltech Spidey is more preferable?
Why is there like 4 or 5 broken figure threads up?
>>10981037use a pin vise. If you dont have one buy one. Its a helpful tool as it isI was not paid by the PinVise® company for this advertisement.
>>10981751And every single one mentions a pinvise… what’s going on here?
>>10981063>step one, Buy pin vice >step two, drill hole in broken peg. Don't go all the way through the peg.>step three, glue either a toothpick or some wire into hole. Let it set.>step four, Pull out peg.If you want to fix the stand, drill out the stand side and glue a piece of wire through the stand and broken peg.
>>10983017This, drill the fucker
What the fuck is a pinvise?
>>10985634>look ma I'm on the internet!
>>10981037classic revoltech trash peg
>>10981751Hamhands: an epidemic
